[1] M. J. Muhammad
et al., "Thermal performance enhancement of flat-plate and evacuated tube solar collectors using nanofluid: A review,"
Int. Commun. Heat Mass Transf., vol. 76, pp. 6–15, 2016. [Online]. Available: doi:
10.1016/j.icheatmasstransfer.2016.04.005
[2] O. Mahian
et al., "A review of the applications of nanofluids in solar energy,"
Int. J. Heat Mass Transf., vol. 57, no. 2, pp. 582–594, 2013. [Online]. Available: doi:
10.1016/j.ijheatmasstransfer.2012.10.037
[3] X. Wang, X. Xu, and S. U. S. Choi, "Thermal conductivity of nanoparticle-fluid mixture,"
J. Thermophys. Heat Transf., vol. 13, no. 4, pp. 474–480, 1999. [Online]. Available: doi:
10.2514/2.6486
[4] X. Cui
et al., "A graphene composite material with single cobalt active sites: A highly efficient counter electrode for dye-sensitized solar cells,"
Angew. Chem. Int. Ed., vol. 55, no. 23, pp. 6708–6712, 2016. [Online]. Available: doi:
10.1002/anie.201601464
[5] M. E. A. Slimani
et al., "A detailed thermal-electrical model of three photovoltaic/thermal (PV/T) hybrid air collectors and photovoltaic (PV) module: Comparative study under Algiers climatic conditions,"
Energy Convers. Manag., vol. 133, pp. 458–476, 2017. [Online]. Available: doi:
10.1016/j.enconman.2016.10.062
[6] P. Ooshaksaraei, K. Sopian, S. H. Zaidi, and R. Zulkifli, "Performance of four air-based photovoltaic thermal collectors configurations with bifacial solar cells,"
Renew. Energy, vol. 102, pp. 279–293, 2017. [Online]. Available: doi:
10.1016/j.renene.2016.10.038
[7] S. Ladjevardi
et al., "Applicability of graphite nanofluids in direct solar energy absorption,"
Sol. Energy, vol. 94, pp. 327–334, 2013. [Online]. Available: doi:
10.1016/j.solener.2013.05.021
[8] A. Zamzamian
et al., "An experimental study on the effect of Cu-synthesized/EG nanofluid on the efficiency of flat-plate solar collectors,"
Renew. Energy, vol. 71, pp. 658–664, 2014. [Online]. Available: doi:
10.1016/j.renene.2014.06.003
[9] A. del Amo, A. Martínez-Gracia, A. A. Bayod-Rújula, and J. Antoñanzas, "An innovative urban energy system constituted by a photovoltaic/thermal hybrid solar installation: Design, simulation and monitoring,"
Appl. Energy, vol. 186, pp. 140–151, 2017. [Online]. Available: doi:
10.1016/j.apenergy.2016.03.060
[10] E. Sani
et al., "Potential of carbon nanohorn-based suspensions for solar thermal collectors,"
Sol. Energy Mater. Sol. Cells, vol. 95, no. 11, pp. 2994–3000, 2011. [Online]. Available: doi:
10.1016/j.solmat.2011.06.025
[11] H. K. Gupta, G. D. Agrawal, and J. Mathur, "An experimental investigation of a low temperature Al₂O₃-H₂O nanofluid based direct absorption solar collector,"
Sol. Energy, vol. 118, pp. 390–396, 2015. [Online]. Available: doi:
10.1016/j.solener.2015.05.040
[12] J. Liu
et al., "A combined numerical and experimental study on graphene/ionic liquid nanofluid based direct absorption solar collector,"
Sol. Energy Mater. Sol. Cells, vol. 136, pp. 177–186, 2015. [Online]. Available: doi:
10.1016/j.solmat.2014.12.027
[13] A. Yurddaş, "Optimization and thermal performance of evacuated tube solar collector with various nanofluids,"
Int. J. Heat Mass Transf., vol. 152, p. 119496, 2020. [Online]. Available: doi:
10.1016/j.ijheatmasstransfer.2020.119496
[14] E. Jahanshahi, A. Hosseinkhani, and S. M. H. Moahmmadi, "Manufacturing and simulation of a solar humidification-dehumidification desalination system," Modares Mechanical Engineering, vol. 16, no. 12, pp. 239–248, 2017. (in Persian)
[15] Y. Zhang
et al., "Application of solar energy in water treatment processes: A review,"
Desalination, vol. 428, pp. 116–145, 2018. [Online]. Available: doi:
10.1016/j.desal.2017.11.021
[16] Z. Shojaeian and S. M. Kashefipour, "Numerical modeling of hydraulic jump in stilling basin of Nemrood reservoir dam," Water and Soil Science, vol. 23, no. 2, pp. 283–295, 2013. (in Persian)
[17] A. Alipoor and P. Abbaspour, "Thermal Performance Analysis of a Swiss-roll Micro Combustion Chamber for Micro Thermophotovoltaic Applications," Fuel and Combustion, vol. 17, no. 1, pp. 51–71, 2024. (in Persian)
[18] K. Sampathkumar and P. Senthilkumar, "Utilization of solar water heater in a single basin solar still—an experimental study,"
Desalination, vol. 297, pp. 8–19, 2012. [Online]. Available: doi:
10.1016/j.desal.2012.04.002
[19] Y. Belkassmi, K. Gueraoui, L. El Maimouni, N. Hassanain, and O. Tata, "Numerical investigation and optimization of a flat plate solar collector operating with Cu/CuO/Al₂O₃-water nanofluids,"
Transactions of Tianjin University, vol. 27, pp. 64–76, 2021. [Online]. Available: doi:
10.1007/s12209-021-00251-5
[20] P. Filipovic, D. Dovic, B. Ranilovic, and I. Horvat, "Numerical and experimental approach for evaluation of thermal performances of a polymer solar collector,"
Renewable and Sustainable Energy Reviews, vol. 112, pp. 127–139, 2019. [Online]. Available: doi:
10.1016/j.rser.2019.05.054
[21] A. A. Hawwash, A. K. Abdel Rahman, S. A. Nada, and S. Ookawara, "Numerical Investigation and Experimental Verification of Performance Enhancement of Flat Plate Solar Collector Using Nanofluids,"
Applied Thermal Engineering, vol. 130, pp. 363–374, 2018. [Online]. Available: doi:
10.1016/j.applthermaleng.2017.11.118
[22] S. Mesfin, V. V. Rao, and L. S. Sundar, "Analysis of thermal efficiency of solar flat plate collector working with hybrid nanofluids: An experimental study," Materials Research Proceedings, vol. 43, 2024.
[23] M. Alghamdi, A. A. Memon, T. Muhammad, and M. R. Ali, "A numerical investigation of a photovoltaic thermal system contained a trapezoidal channel with transport of silver and titanium oxide using the water as base fluids,"
Case Studies in Thermal Engineering, vol. 47, p. 103056, 2023. [Online]. Available: doi:
10.1016/j.csite.2023.103056
[24] M. Sangeetha, S. Manigandan, M. T. Chaichan, and V. Kumar, "Progress of MWCNT, Al₂O₃, and CuO with water in enhancing the photovoltaic thermal system,"
International Journal of Energy Research, vol. 44, pp. 821–832, 2020. [Online]. Available: doi:
10.1002/er.4936
[25] H. A. Kazem, M. T. Chaichan, A. H. Al-Waeli, and K. Sopian, "Investigation of a nanofluid-based photovoltaic thermal system using single-wall carbon nanotubes: An experimental study,"
International Journal of Energy Research, vol. 45, pp. 10285–10303, 2021. [Online]. Available: doi:
10.1002/er.6522
[26] K. R. Aglawe, R. K. Yadav, and S. B. Thool, "Fabrication, experimentation and numerical simulation of micro channel heat sink for enhancing thermal performance of electronic devices,"
International Journal on Interactive Design and Manufacturing (IJIDeM), pp. 1–16, 2023. [Online]. Available: doi:
10.1007/s12008-023-01130-4
[27] E. Yousefi, A. A. Nejad, and N. A. Sayyar, "A new approach for simultaneous thermal management of hot and cold sides of thermoelectric modules,"
Applied Thermal Engineering, vol. 233, p. 121156, 2023. [Online]. Available: doi:
10.1016/j.applthermaleng.2023.121156